Many preamps have an output trim or fader.It can also refer to bringing a signal that is above the range of line level, or outside the norms of line level, into the range of “line level.Raising the source to “Nominal Level” implies taking a signal of low level (like a mic or direct instrument) and bringing it up to the range of what we would call “Line Level.”.This is usually the first amplifier stage and is used to raise the source signal to “nominal level.”.Extraneous noise (audio masking) can be making something seem quiet.Excessively or poorly damped rooms can soak up too much sound and “feel quiet” even when the level is loud.Is there a problem with the components?.The VRS8 monitor knob adjusts from -45dB to +7dB from the “MIX OUT” in the VRS8 panel.Levels should be clear and present but not too loud to listen. If there is a trim control, adjust it so that there is suitable range.If there is a choice of “-10” or “+4,” choose “+4.”.Check that your power amp or speakers that follow the monitor out are calibrated to work with your interface.Check that the Mix Output is reasonable, most would agree that peaks around -18dBFS are standard.If you find yourself adding or subtracting a large amount, check the following:.There is sometimes a lot of attenuation or gain at this stage – it can be a source of issues.This refers to the output after your mix bus or mix output – changes here only affect monitoring and are not printed to the.Controller on control protocol, like MIDI.Microphone – Be sure to engage phantom power if needed.This would be the instrument, be it acoustic or electronic or even a human voice.Local headphones will always share the source with Line Out 3-4.Use when you want a headphone mix different from your main mix, or when using an external monitor controller or headphone system.” “STUDIO MODE feeds the Line Out 3-4 and Phones with DAW 3-4.To use this mode, create a headphone mix in your DAW and route it out DAW 3-4 before selecting “B” in the mixer panel.DAW 3-4 out feeds line out 3-4 & local headphones.STUDIO MODE is labeled “B” and is specially tailored to users who create a separate headphone mix from the DAW 1-2.Use Line Out 3-4 for an external headphone amp, mix deck, or processing chain “PRODUCTION MODE is default, and feeds the Line Out 3-4 and Phones with your MIX OUT, which includes DAW 1-2.Line Out 3-4 can be sent to an external headphone amp in your tracking room.DAW 1-2) feeds the local headphones and Line Out 3-4 PRODUCTION MODE is labeled “A” and will be the default for most users.Line out 3-4 & local headphones share a source & trim fader.The MODE selection determines how your local headphones & line out 3-4 are fed
0 kommentar(er)
